D4 Initial Configuration and Setup

Process steps for configuration of Idrive D4 for Customers. (Firmware Update, Idrive Default Configuration, Install Hard Drive)

Check Firmware version to verify that this main board has the NOR_FLASH "S8R15" installed

The firmware for old DVRs with NAND-FLASH starts with S5R16 or S7R15, while that for NOR-FLASH starts with S8R15. This is the easiest way to identify old (with NAND-FLASH) or new (NOR-FLASH) DVRs.

Enter the serial number into Admin Center

Get the Serial Number from sticker on the back of the unit. (MDRxxxxxxx type number) to

Enter it into Admin Center.

-Support/Devices/New D4-DVR Click on ADD and enter the S/N

Install Hard Drive into the Hard Drive carriage

step1

Step 2

Do not reinstall the Hard Drive carriage into the D4-DVR until after configuration steps are completed

Setup the D4 for configuration

Plug in the Power Cable

Plug in the Monitor Cable

Plug in the Camera Cable

Turn power supply on

Insert the firmware and configuration SD Card into the unit

Turn the Key on ( wait ~40 Seconds for video and ~25 seconds for “Loading Disk”)

Press STOP on Remote Control to stop recording.

Confirm Application version is the latest

Check for NOR-FLASH Version to verify DVR is the updated type (NOR-FLASH starts with S8R15)

Using the Remote - MENU>SYSTEM>SYSTEM INFO> (S8R15_130701_Defezdvr_en_NTSC)

Compare the installed version to the latest version. If different update it to the current release.

Update firmware MENU>SYSTEM>SYSTEM INFO>APP UPDATE (S8R15_130701_Defezdvr_en_NTSC.tar)

Note - This file is located on the SDcard that you have inserted in the D4

Install the Idrive standard configuration

Read the configuration file from the SD card MENU>SYSTEM>CONFIG SETUP>CONFIG IMPORT> the UNIT will restart the App