Difference between revisions of "D4 Initial Configuration and Setup"
| Line 46: | Line 46: | ||
23) Box up unit with serial number on the outside of the box | 23) Box up unit with serial number on the outside of the box | ||
| − | |||
| − | |||
Revision as of 17:13, 12 August 2013
Process steps for configuration of Idrive D4 for Customers. (Firmware Update, Idrive Default Configuration, Install Hard Drive)
1) Record Serial number from sticker on the back of the unit. ( Is this on the outside of the box?) to enter into global center later?
2) Remove hard drive carriage and install hard drive. Do NOT put back into system yet.
3) Plug in the Power Cable
4) Plug in the Monitor Cable
5) Plug in the Camera Cable
6) Turn power supply on
7) Insert the firmware and configuration SD Card into the unit
8) Turn the Key on ( wait ~40 Seconds for video and ~25 seconds for “Loading Disk”)
9) Press STOP on Remote Control to stop recording.
10) Update firmware MENU>SYSTEM>SYSTEM INFO>APP UPDATE (S5R16_0213_4EnNWifi.tar)
11) Read the configuration file from the SD card MENU>SYSTEM>CONFIG SETUP>CONFIG IMPORT> the UNIT will restart the App
12) Press STOP on Remote Control to stop recording.
13) Confirm the config MENU>LIVE>BACKGROUND = SEMI TRANSPARENT? If not the config did not get set.
14) Enter the serial number (from STEP 1) into the “LICENSE ID” MENU>MOTOR>LICENSE ID
15) Turn Key OFF
16) Remove SD Card
17) Install the hard drive
18) Turn the key ON
19) Format the hard drive MENU>STORAGE>FORMAT
20) Push record and verify that it can write to the hard drive.
21) Push stop
22) Turn the Key and Power supply off.
23) Box up unit with serial number on the outside of the box