USB Config Files
Revision as of 23:25, 15 February 2019 by Mark (talk | contribs) (→ip.cfg - Sets IP Address & Netmask of the camera)
USB Configuration Files
ASCII files that can be used to change the X2 configuration using a USB Stick.
To have the camera read the USB stick the idrive.cert must be present
adresa.cfg - Sets Base Station Address
192.168.0.10 is default
ip.cfg - Sets IP Address & Netmask of the camera
192.168.0.11 - 192.168.254.254 Standard IP Address Range
255.255.0.0 Standard Network Mask
Note: If the device is run through factory tool the setting will reset to what is set in AC
limit.cfg
Not sure
mac.cfg - changes the MAC Address for the Wifi
00127B4B5F4E
port.cfg - Sets the Port for transfers
9090
reg1.cfg
Not Sure
==router.cfg - Sets SSID for Wifi connection (X1 Only)
For X2 see wifi-settings.cfg