D8 repair and reprocessing

D8 Repair

Verify the reported issue.

Check for physical damage to the connectors or case

Motherboard Replacement

Open the DVR case

• Remove the SSD Sled

• Remove the two top screws on the front of the D8

• Remove the 4 screws on the back panel

• Slide the top cover back and slowly lift up

• Disconnect the 3 cables to the Mother Board

• Lift off the Top cover and set aside

Remove Back Panel

• Disconnect the cables from the Mother Board, GPS and Cellular Modules

Move GPS, SIM and Cellular Module to replacement board

GPS Module

• Remove the two screws securing the module.

• Apply Blue Locktite to the mounting studs on the new board

• Insert the two screws to secure the module (do not over torque)

Cellular Module

• Remove the two screws securing the module.

• Apply Blue Locktite to the mounting studs on the new board

• Insert the module into the socket

• Insert the two screws to secure the module (do not over torque)

SIM Card

• Push the button to the right of the SIM socket.

• Remove the SIM and insert it into the socket on the new Mother Board

• Record the last 4 digits of the SIM Card

Remove and Replce th Motherboard

• Remove the 7 screws holding the board in the case

• Verify that the replacement board has all of the same Heat tape and foam rubber

• Apply Blue Locktite to the mounting studs on the case

• Insert the 7 screws to secure the board (do not over torque)

D8 Reprocessing

Configure for customer