X1 V7 series Main Board Manufacturing and Programming
Important Information
- All SD cards need to be unlocked (all SD cards have a lock/unlock switch). It depends on the SD Cards‟ provider whether or not the card needs to be formatted. In all cases if the SD Card needs formatting do not use the quick version.
The power supply 12V 1A for the programming board needs to be stabilized type.
Copyright Information
This document contains proprietary information that is protected by copyright. No part of this document may be photocopied, reproduced, or translated to another language without the prior written consent of Idrive Inc.
About This Document
This document contains the information necessary to produce a fully programmed Idrive Main board suitable for building of an Idrive X1 series camera. This includes all programming, testing, focus of lenses and bar code label.
Idrive X1 V7.0.x PCB Assembly Notes
SMT Placement - Use the supplied pick and place information supplied by Idrive
Through Hole / Hand parts - Document by vendor process
BiColor LED Mounting Height requirement is 6.25mm +/- 0.1MM from base of LED to PCB surface
IR Leds Mounting Height ( requirement is 12.25mm +/- 0.1MM from base of LED to PCB surface
Top Level Main Board Assembly Materials
| Station 1 – “Main Board” Assembly |
|---|
| Idrive X1 PCB |
| SD Card |
| Lens Holders (with 2 screws each) |
| Lenses (2 per assembly) |
| 3 Bar code Labels with Serial number |