Difference between revisions of "Idrive X1 v7 Test Reports"
| Line 31: | Line 31: | ||
3. J4 is unmounted – to be checked the DigiKey stock (ED90342TR-ND) | 3. J4 is unmounted – to be checked the DigiKey stock (ED90342TR-ND) | ||
| + | |||
4. The silk for S/N on the board must be fill with white color | 4. The silk for S/N on the board must be fill with white color | ||
| + | |||
5. The C22 shape clearance is very close | 5. The C22 shape clearance is very close | ||
| + | |||
5. If the RTC feature is not implemented in the actual V7.0 version then the Y1 crystal may be missing – to be tested | 5. If the RTC feature is not implemented in the actual V7.0 version then the Y1 crystal may be missing – to be tested | ||
| + | |||
7. In the fabricartion notice must be added thermal specifications for the Microphone | 7. In the fabricartion notice must be added thermal specifications for the Microphone | ||
| + | |||
8. In the fabricartion notice must be added thermal specifications for the plastic connectors | 8. In the fabricartion notice must be added thermal specifications for the plastic connectors | ||
Latest revision as of 12:10, 7 November 2012
Summary
Hardware test reports and suggestions for Idrive X1 Main Board v7.
Tests
Hardware tests:
Sleep Mode Tests
1. Need to establish the exact current in Sleep Mode.
2. Need to see how fast the Event Mode can be start
3. Need to see how many seconds from the Wake Up Trigger will need to start recording.
Power Supply Tests
Firmware Changes
The FREX pin should not be initialization as output in the camera driver because is connected to GND or to establish if is necessary to place resistors ??
Recommendations
1. J3 connector is to close to the hole MH1 ??
2. J15 must be right angle or vert ??
3. J4 is unmounted – to be checked the DigiKey stock (ED90342TR-ND)
4. The silk for S/N on the board must be fill with white color
5. The C22 shape clearance is very close
5. If the RTC feature is not implemented in the actual V7.0 version then the Y1 crystal may be missing – to be tested
7. In the fabricartion notice must be added thermal specifications for the Microphone
8. In the fabricartion notice must be added thermal specifications for the plastic connectors