Difference between revisions of "USB Config Files"
Jump to navigation
Jump to search
| Line 47: | Line 47: | ||
<br> | <br> | ||
| − | ==router.cfg - Sets SSID for Wifi connection (X1 Only) | + | ==router.cfg - Sets SSID for Wifi connection (X1 Only)== |
bwifi is the default | bwifi is the default | ||
| Line 55: | Line 55: | ||
<br> | <br> | ||
old | old | ||
| + | |||
==shock.cfg - Setting of G-force in old X1== | ==shock.cfg - Setting of G-force in old X1== | ||
Revision as of 23:28, 15 February 2019
USB Configuration Files
ASCII files that can be used to change the X2 configuration using a USB Stick.
To have the camera read the USB stick the idrive.cert must be present
adresa.cfg - Sets Base Station Address
192.168.0.10 is default
ip.cfg - Sets IP Address & Netmask of the camera
192.168.0.11 - 192.168.254.254 Standard IP Address Range
255.255.0.0 Standard Network Mask
Note: If the device is run through factory tool the setting will reset to what is set in AC
limit.cfg
Not sure
mac.cfg - changes the MAC Address for the Wifi
00127B4B5F4E
port.cfg - Sets the Port for transfers
9090
reg1.cfg
Not Sure
router.cfg - Sets SSID for Wifi connection (X1 Only)
bwifi is the default
Note: For X2 see wifi-settings.cfg
old
shock.cfg - Setting of G-force in old X1
- //eveniment pe acceleratie
- WriteRegistru(CTRL_REG1,0x87);
0x20 0x85 0x00
- WriteRegistru(CTRL_REG2,0x88);
0x21 0x08 0x00
- WriteRegistru(CTRL_REG3,0x22);
0x22 0x22 0x00
- WriteRegistru(FF_WU_THS_L, 0x99);
0x34 0x99 0x00
- WriteRegistru(FF_WU_THS_H, 0x29);
0x35 0x29 0x00
- WriteRegistru(FF_WU_DURATION, 0x00);
0x36 0x00 0x00
- ReadRegistru(HP_FILTER_RESET); //dummy read
0x23 0x00 0x01
- WriteRegistru(FF_WU_CFG, 0x4A);
0x30 0x62 0x00
- ReadRegistru(FF_WU_ACK);
0x32 0x00 0x01