Difference between revisions of "Driver ID Specs"
Jump to navigation
Jump to search
| Line 17: | Line 17: | ||
| − | == Hardware Requirements == | + | == Hardware Requirements == |
| + | |||
| + | * RS232 connection using Idrive X1P external connector - mini HDMI; | ||
| + | * 5V power connection using Idrive X1P external connector - mini HDMI; | ||
== Software Requirements == | == Software Requirements == | ||
Revision as of 10:30, 25 September 2013
Introduction
Driver ID component is a Idrive X1P accessory that provides driver identification based on iButton key and a one wire protocol reader.
Overall Description
Driver ID component will contain the following:
* iButton key(http://www.maximintegrated.com/products/ibutton/ibuttons/)
* Idrive designed one wire protocol key reader using an Atmel xxx micro-controller. * Idrive designed PCB * Idrive designed micro-controller software.
System Features
Send a driver identification code to FW via RS232(mini HDMI Port) that will be logged and attached to events header.
Hardware Requirements
- RS232 connection using Idrive X1P external connector - mini HDMI;
- 5V power connection using Idrive X1P external connector - mini HDMI;