Difference between revisions of "Configure VPN Client"

@@ Line 1: / Line 1: @@
-Run Winbox.exe select router from list and click connect
-[[File:Mikrotik-client1.png|center]]
-Select "Interfaces" from the left menu and enable both "wlan1" and "ppp-out1".
-[[File:Mikrotik-client2.png|1024px|center]]
-Connect your 3G USB dongle and restart router.
-Return on "Interface List" and double-click "ppp-out1" and make sure that "usb1" option is selected. If the "Port" drop-down list is empty then your 3G dongle is not supported.
-Our 3G USB worked by default without any other configuration. Click on "Advanced Mode" if your SIM does require mobile carrier configuration.
-[[File:Mikrotik-client3.png|1024px|center]]
-[[File:Mikrotik-client4.png|1024px|center]]
-[[File:Mikrotik-client5.png|1024px|center]]
-Return on "Interface List" double-click "wlan1", select "Wireless" tab and complete the fields as in picture.
-[[File:Mikrotik-client6.png|1024px|center]]
-Select "Bridge" from the left menu and add new bridge.
-[[File:Mikrotik-client7.png|1024px|center]]
-From the same window select "Ports" tab and add the following interfaces as in picture.
-[[File:Mikrotik-client8.png|1024px|center]]
-Select IP->Address List from the left menu and add a new address.
-[[File:Mikrotik-client9.png|1024px|center]]
-Return to "Bridge" and add a new bridge.
-Make sure the "ARP" is disabled and enter the MAC Address: 00:00:5E:80:01:01 then select "STP" tab and check "Protocol Mode: rstp".
-[[File:Mikrotik-client13.png|1024px|center]]
-[[File:Mikrotik-client11.png|1024px|center]]
-Select "Ports" tab from "Bridge" interface and add "ether1" and "wlan1" to "bridge_tunnel".
-[[File:Mikrotik-client12.png|1024px|center]]
-Select "PPP" from the left menu then go to "Profiles" tab and add new profile.
-Complete the fields then select "Protocols" tab and check "yes" under "Use Encryption".
-[[File:Mikrotik-client15.png|1024px|center]]
-Return to "Interface List" and add new "SSTP Client".
-[[File:Mikrotik-client16.png|1024px|center]]
-In the "Dial Out" fill "Connect To:" with the VPN Server public IP, set port to 1723, enter the user name and password that you have created on VPN Server.
-Uncheck "pap" and "chap" boxes from "Allow".
-[[File:Mikrotik-client17.png|1024px|center]]
-If the VPN Server is configured then the status must be connected.
-If the VPN Server is not configured then check [[Configure VPN Server]].
-[[File:Mikrotik-client18.png|1024px|center]]

Difference between revisions of "Configure VPN Client"

Latest revision as of 18:16, 7 November 2014

Navigation menu

Search