Mark: Created page with "==Idrive X2 Programming Station Documentation == ===Programming Station Components=== 400px| {| class="wikitable" |- !'''X2 Programming ..."

2015-07-20T21:22:46Z

Created page with "==Idrive X2 Programming Station Documentation == ===Programming Station Components=== thumb|400px| {| class="wikitable" |- !'''X2 Programming ..."

New page

==Idrive X2 Programming Station Documentation ==

===Programming Station Components===

[[File:idr_x2_pgmr_sta1.jpg|thumb|400px|]]

{| class="wikitable"
|-
!'''X2 Programming Station Components '''
|-
|Windows 8 Computer with Monitor and speaker(s)(see requirements below)
|-
|Bar Code Scanner
|-
|Lens Focus Charts
|-
|Micro SD card reader
|-
|Idrive X2 Programmer Fixture
|-
|I/O Loopback Test Adapter
|-
|DC 12V/1A '''LINEAR''' power supply
|-
|USB type B cable
|-
|USB to Ethernet adapter
|-
|Cat5 Cable
|-
|Power cable for X2
|-
|X2 Serial Programming cable
|-
|}

<br\>

===X2 Programming Computer Setup===

====Computer Hardware Minimum Requirements ====

::*Monitor (needs to support 1600X1200 screen resolution)

::*Speaker(s)

::*Windows 8.1 Professional recommended

::*1GB RAM

::*100 GB Hard Disk

::*2 Network Interface adaptors (NICs)

::* Keyboard and Mouse

====Network Configuration====

: Network Connection to the Programming Fixture

::* IP address: 192.168.0.10

::* Subnet Mask: 255.255.0.0

::* Default gateway: Blank

: Network Connection with access to internet

::* DHCP or as required by location

<br\>

====Computer Software Requirements====

* TeamViewer V9 (http://www.teamviewer.com ) - personal license. Install TeamViewer - during setup you need to choose the Personal license installation!

* Idrive Factory Tools 3.2.x

* Future Technologies USB Driver for X2 Programming Fixture (http://www.ftdichip.com/Drivers/VCP.htm)

* Firefox Web browser (https://www.mozilla.org/en-US/firefox/new/)

 

===X2 Programming Fixture Setup===

[[File:programmer.png|thumb|400px|]]

<br\><br\>

====Computer Connections====

::* Connect the 12volt Power Supply to the Power Connector

::* Connect the USB cable from Programming computer to USB Type B connector

::* Connect the USB-to-Ethernet Adapter to the Programming Computer with a Cat5 (Network) Cable

 

====Idrive Camera Connections====

::* Connect "Idrive Cable" to the Device to be programmed

::* Connect the "Programming Connector" to the Device to be programmed

::* Connect the USB-to-Ethernet Adapter to the Device to be programmed

<br\><br\><br\><br\>

'''Turn On the Power switch''' and leave the programmer on for the batch of boards.(you do not need to turn it off to program the next board)

Manufacturing:Idrive X2 Programming Station Documentation - Revision history

Mark: Created page with "==Idrive X2 Programming Station Documentation == ===Programming Station Components=== 400px| {| class="wikitable" |- !'''X2 Programming ..."