View source for Manufacturing:X2 Secondary Configuration/Testing

==Idrive X2 Secondary Testing (Bi-Color LEDS, Accelerometers, IR LEDs, Wifi Transfers, GPS, labeling)==

'''Note:'''The Idrive X2 programmer may also be used to perform this portion of the programming provided a wireless router is configured and connected to the system. For better throughput and to reduce the number of wireless networks in a factory environment it is recommended that the X6 Fixture be used. Because this document is intended to support production the X6 Fixture process is shown here.

<br\>

[[File:x2_x6_station.jpg|400px|]]

[[#Appendix C - Idrive X2 Secondary/Final Test Station Documentation  | Idrive X2 Secondary/Final Test Station Setup]]

<br\>

===Stage 2 Initialize X6 Fixture===

[[File:x6fixtswitchesman.jpg|600px|]]

'''1.''' Turn on the power toggle switch of the X6 Fixture

'''2.''' Connect up to 6 cameras into the x6 programmer using the 6 pin power cables

'''3.''' Press any one of the 6 Ignition push buttons to turn on the test cameras

'''4.''' When the X2 device's LED are Green/Green the camera is ready to test.

<br\>

===Test X2 Internal Accelerometer function===

'''1.'''Gently shake each camera to trigger a shock event

::* Right LED will turn red. Both LEDs green after event finishes recording.

::* Alarm/W-Panic and Door events may be triggered by pressing the corresponding push button. (these events are tested in at the first test station so this is optional)

<br\>

===Transfer the event(s) to the Test Station===

'''1.''' Press any one of the 6 Ignition push buttons to initiate transfer of events to the test station.

===Verify the Events in Factory Tool===

'''1.''' Factory Tool verify that each camera downloads

[[File:ft_transfer_results.jpg|600px|]]

::- Red text is bad (Camera transfered but no shock event was downloaded or failed GPS Data)

::- Black text is good (Camera is pending the label printing process)

::- Green text is good (Passed Accelerometer, GPS and Label application)

::- No text (camera did not download to test station. WiFi failure?)

<br\><br\>

===Print Serial Number, Barcode, MAC Address Labels===

[[File:x2_label_flow.jpg|700px|]]

If the transfer(s) and tests are successful Labels for the device can be printed. You must print the labels within 240 seconds* or the tests must be rerun.

:: *This timeout length can be changed by Idrive if needed to help with process flow.

[[File:ft_print_240sec.jpg|300px|]] [[File:ft_print_115sec.jpg|250px|]]

Click on "Print(230sec until close)" link to start the print dialog

::* When Print is selected the corresponding Camera will flash its LEDs: GREEN/GREEN  OFF/OFF  RED/RED ... repeat

::* You must confirm the label Printed and was attached to the camera before the next Camera can have the label printer.

Click on "Quick Print"

[[File:ft_print_dialog.jpg|400px|]]

Click On Confirm Label printed if successful.

[[File:ft_print_printed.jpg|200px|]][[File:ft_print_printed2.jpg|250px|]]

Tear-off the three labels from the printer. Place one Label on the back of the camera covering the case screw as shown. Advance the remaining two labels to Final Assembly/ Packaging.

[[File:ft_barcode_on_case.jpg|400px|]]


<br\>